Our products can be delivered fully finished or ready-to-assemble parts. We work with aluminium sheet from 0.6mm to 1.2mm thick, galvanized and stainless steel.
PIPES
Tongue-and-groove joint system and special beads and beads on both longitudinal sides of 1m or 1.25m long and 30mm stud. The Standard measures range goes from ½ to 28 " and thicknesses from 30 to 100mm ... more details and photo gallery
ELBOWS
Standard elbows 90 and 45 ° inclination angle, composed of three whole and two half pieces and 30mm stud. Sizes go from ½ to 24“ with thicknesses from 30 to 100mm ... more details and photo gallery
GRAFT
Standard grafts of 90 and 45 ° angle with longitudinal beads, bead on the end and 30mm stud. You can also give the desired angle. Sizes from ½ to 24“ with thicknesses from 30 to 100mm ... more details and photo gallery
CONES OR REDUCTIONS
Centred and off-centred cones of any diameter of one or several assembly parts. Longitudinal and ends beads following projects´ request...more information and pictures gallery
CRIMPED BOXES
Cylindrical, round, oval sets in two, three or four parts each. Filters for grafting in these boxes with the necessary degree of tilt.
BOTTOM PARTS
Bottom parts for small tanks or boilers of large size or diameter, with or without envelopes ... more information and pictures gallery
HOPPERS
Centred and off-centred in all measures, with reductions of square to round terminals.
If you want information about our rates use our contact request.
We work with leading brands in the industry as ...
